RocketFish RF-WHTIB-A User's Guide download pdf (Page 17)

RF-WHTIB-A

Sound interference

• Move the wireless sender and wireless receiver slowly

to find the best reception position for your system.

• Shorten the distance between your wireless sender and

wireless receiver. The maximum distance is 100 feet.

• Other devices, such as cordless phones or microwaves,

may cause interference with the wireless sender and

wireless receiver. Try turning off one device at a time to

determine which device is causing interference. Make

sure the wireless sender is more than 18 inches away

from any Wi-Fi routers.

No communication between

the sender and receiver

• Make sure that the power cords are connected

correctly.

• After the power switches have been turned on on both

the wireless sender and wireless receiver, the front

panel LEDs should light. If they are solidly on, a

communication link has been successfully established

between the units. If they are flashing on one or both

units, press and hold the CONNECT button on either

the wireless sender or wireless receiver for two

seconds. (Both the wireless sender's and the wireless

receiver's CONNECT buttons are on the bottom.) This

will put the unit into the “connection mode” for about

30 seconds. During this period the CONNECT button

on the other unit must also be pressed for two seconds

so that it will also enter “connection mode.” The system

proceeds with the connection process between the

wireless sender and wireless receiver. While in

“connection mode,” the LED indicators blink at a faster

rate. When an active link is established between the

wireless sender and wireless receiver, the LED

indicators will be solid on and will not blink.

Note: Try pressing the CONNECT buttons again if the LED indicators keep

blinking after 30 seconds.

Problem Solution

RF-WHTIB_13-0050_MAN_V1_ENG.fm Page 17 Tuesday, March 26, 2013 11:51 AM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

RocketFish RF-WHTIB-A User's Guide Page 17