RocketFish RF-RBWS02 User's Guide download pdf (Page 26)

To turn off the transmitter:

• Remove the 3.5 mm plug from the back of the unit and the transmitter

will automatically stop transmitting. The TX light will go out.

Troubleshooting

Check this list for a possible solution before calling for service.

Problem Solution

No sound • Make sure that all of the cables are connected correctly.

• Make sure that the audio source (at the unit or your

sender) is present.

• Make sure that the sender/receiver is not muted. (The

source Tx/Rx indicator is blinking when it is muted.)

• Make sure that the unit or your receiver's output is

connected to the speaker system, which is powered on

and working.

No communication

between the unit and your

device

• Make sure that the Hub Status switch on the

sender/receiver is set correctly.

• Make sure that the power LEDs on the sender/receiver

and other devices light solid blue/green. If the power

LEDs blink slowly, it means there is no active link

between the devices. Unplug the AC adapters, then plug

them back in and try to establish the link again. For

more information, see “Establishing communication”

on page 21.

No response when you

press any button

• Try disconnecting the main power to reset the device.

Connecting a source device • If your network is already full with transmitters when

joining is attempted, the Source LED will blink three

times and then turn off. Remove (power down) a

transmitting device and try again.

RF-RBWS02_09-0535_MAN_ENG_V1.fm Page 26 Thursday, August 27, 2009 7:39 PM

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33

No comments

RocketFish RF-RBWS02 User's Guide Page 26